- About Us
- Our Dealers
- Contact Us
Under the misalignment condition of two shafts of the equipment, the teeth contact in case of straight cut hub will be as minimum as shown in the figure no. 1.
Under heavy loads the ends of the hub teeth will get damaged resulting in the excessive play between hub & sleeve. This leads to a reduction in the life of the coupling.
The triple crowned teeth hub is manufactured on a fully automatic hobbing machine with a built-in crowing attachment which is controlled by hydraulic & electronic systems. Under the misalignment condition of two shafts on the equipment, due to the curvature on teeth flank the contact area is much more. This means that there is an increase in the life of the coupling.
In case of straight tooth gear coupling the maximum allowable angular misalignment (μ) is .1/2 deg. and in case of Nu Teck Triple Crowned tooth Gear Coupling the misalignment is 1.1/2 deg.